Memberships from H-Town AC Repair

HVAC » Memberships from H-Town AC Repair

Leave A Request And
We Will Contact You Shortly


Extend Life - Maintain Efficiency - Peace of Mind

Screenshot 2022-06-26 at 18-52-25

No overtime rates (straight time)

Screenshot 2022-06-26 at 18-52-25

Pusservice over non agreement

Screenshot 2022-06-26 at 18-52-25

Discounts on service, parts and labor



One scheduled maintenance for your cooling system equipment:

  • Check Thermostat – test for proper operation, calibrate
  • Check AMP draw on compressor
  • Check condensate drain
  • Check condition of filter
  • Pressures & sub cool
  • Condensate Drain – flush and treat with anti-algae
  • Blower Motor – measure amperage and voltage for proper operation
  • Inspect indoor coil
  • Inspect Condenser Coil and wash with water
  • Safety Devices – inspect for proper operation
  • Electrical Disconnect Box – inspect for proper rating and safe installation
  • Electrical Wiring – inspect and tighten connections
  • Test/inspect contactors for burned, pitted contacts
  • Inspect electrical for exposed wiring
  • Inspect and test capacitors
  • Inspect fan blade
  • Inspect service valves for proper operation
  • Measure Supply/Return temperature differential
  • Inspect ductwork for energy loss
  • Compressor – monitor, measure amperage and volt draw and wiring connections
  • Check for air leak
  • Visual check duct work


One scheduled maintenance for your heating system equipment:

  • Check thermostat operation
  • Inspect electrical wiring
  • Check indoor blower motor
  • Check combustion fan motor
  • Check all safety controls
  • Clean flame sensor
  • Check burners and compartment
  • Check ignition and flame sensor
  • Check all safety controls and wire connections
  • Clean and inspect burners and burner compartment
  • Visual inspection of heat exchanger
  • Clean and check thermocouple /flame sensor
  • Clean and check ignitor
  • Check filters I offer replacement
  • Check and flush condensate drains
  • Inspect venting system for leaks / slope / support / debris
  • Check for required service access / clearances to combustibles
  • Check temperature rise and adjust blower speed as required
  • Test fuel line for leaks at the furnace
  • Check presence of gas pipe pressure test tag
Set your categories menu in Theme Settings -> Header -> Menu -> Mobile menu (categories)
Shopping cart
Mention this coupon codes to get discount:
Start typing to see posts you are looking for.